ALINCO DJ-S11 DATA

The DJ-S11 is a handheld 2M FM amateur radio transceiver with 20 channels (0-19) + CALL Channel; transmits up to 0.45 W on 144-148 MHz (receives 136-174) via 3 internal AA batteries or 4.5 VDC ex-ternal supply.  The Battery icon in upper right corner of Display flashes when battery voltage is low.  The folding antenna must always be in fully extended position & straight up when transmitting.

TO TURN UNIT ON & SET AUDIO VOLUME:  Use DIAL on top right.

TO SELECT FREQUENCY:
To cycle between VFO & Memory Modes, push V/M(MW). Memory Mode is indicated by M & Channel Number in Display; VFO Mode by frequency only. Tune via UP or DOWN keys.
To tune VFO in 1 MHz steps, push F (lowest button on left side of case) & UP or DOWN key.
To tune VFO in 100 kHz steps, push F twice & UP or DOWN key.
To Scan frequencies/channels, push & hold V/M(MW) or SCAN/SHIFT.  UP or DOWN, held in 1 second, changes scan direction.  Same or PTT deselects. When audio tones activated, unit emits beeps as markers when tuning/scanning:  double beep (rising or falling) at MHz, single at 0.5 MHz.

TO SET REPEATER OFFSET.  Push & hold F & push SCAN/SHIFT.  Again push SCAN/SHIFT to cycle among +, -, & Simplex. Push PTT to set.  “T” appears in Display when PL tone is turned on.

TO SET PL TONES:
Push & hold F & push DOWN.  Again push DOWN to select one of 50 subaudible transmit tones. 
Push & hold F & push DOWN to turn tone on/off (indicated by “T” in Display)   Push PTT to set.

TO ENTER A FREQUENCY IN A MEMORY CHANNEL:
Enter VFO Mode & select characteristics (frequency, offset, PL Tone On/Off, tone frequency).
Push & hold F & V/M(MW); use UP or DOWN key to select desired channel. (M & Channel Number/C flash in Display on channels not yet programmed.)  Push V/M(MW) to set memory.  
To erase memory, select channel, push & hold F & V/M(MW), again push & hold F & V/M(MW).

TO SET TRANSMIT POWER:  While transmitting, push SCAN/SHIFT.  Confirmed by L in Display.

TO DEACTIVATE SQUELCH MOMENTARILY: Push MONI.

TO USE LAMP:  Push LAMP (second button from bottom on left side of case) momentarily.

TO SET BEEPS:  
TRANSMIT ALERT: While transmitting, push UP or DOWN.  Alternate this tone between a 1750 Hz steady tone & a telephone ring tone by holding in CALL/BELL while turning unit on.  The tone selected for transmission is replicated in the speaker of the DJ-S11.
AUDIO TONES (receive alarm, key strokes): Hold in MONITOR while turning on.  Same cancels.
RECEIVE ALARM (Carrier activates 3 “telephone” rings): Push & hold F & push CALL/BELL. This setting self-cancels after one ringing cycle and must be manually reset if desired again for later.
TRANSMIT GO-AHEAD: Hold in UP while turning on power.  Same with DOWN cancels.

TO RESET ALL SETTINGS (channel memories are lost):  Hold in F while turning on POWER.